The legal minimum tread depth for a motorcycle tyre is 1mm around the whole circumference whilst for a car it is 1.6mm. This confuses many people as they think it is the same for both.
How do you check motorcycle TYRE tread depth?
Road riding tends to wear out tyres in the middle first, with the grooves closer to the tyre wall often remaining nearly untouched. Make sure you check the grooves down the centre line of the wheel. Remember: the lowest depth you find is the true indicator of how much life your tyres have left.
What is the minimum tire tread depth in Canada?
The legal limit of wear is 1.6 mm or 2/32nds of an inch of tread depth. But most tire makers recommend tires be replaced before the legal limit of wear is reached to ensure better wet-weather stopping power.
What does 3/32 tread depth mean?
If your tread is at 3/32 inch, your tires are nearly worn out, and you should start shopping. At 2/32 inch, you have legally bald tires, and you need to replace them immediately. You can also check tread wear by looking at your tire’s indicator bars.
How long will 3mm tread last?
With all the possible variables taken into account, the minimum average period 3mm of tyre tread depth will last before it reaches the legal limit of 1.6mm is between would be 10,000-20,000 miles but it could be considerably more than that.
What is the tread depth of a new motorcycle tire?
Federal and state regulations dictate that you must have 1/32″ to 2/32″ of tread depth. The middle of the tire sees the most contact with the road and usually wears out first. We can measure your tread depth for you or you can check your wear indicators.
What area of the TYRE should the minimum tread depth cover?
The law requires car tyres to have a minimum tread depth of 1.6mm in a continuous band around the central three quarters of the tyre. To help you judge how much tread you have on your car tyres, manufacturers often mould tread bars at roughly 1.6mm.
What is acceptable tire tread depth?
New tires typically come with 10/32” or 11/32” tread depths, and some truck, SUV and winter tires may have deeper tread depths than other models. The U.S. Department of Transportation recommends replacing tires when they reach 2/32”, and many states legally require tires to be replaced at this depth.
How do you measure tire tread depth in Canada?
Hold the quarter between your thumb and forefinger with the quarter head facing down. Select a point on your tire where tread appears the lowest and insert the figurehead first into one of the grooves. If the top of the figurehead is covered by tread, you’re driving with the legal and safe amount of tread.
What is the minimum tire tread depth in Ontario?
Tires and wheels
The rear tire of a motor vehicle must not have less than 1.5 millimetres (0.06 in.) of tread measured in two adjacent tread grooves. The front tires of a motor vehicle with a gross vehicle rating of more than 4,500 kilograms must have at least 3 millimetres (0.12 in.)
Is 5 32 A good tire tread depth?
6/32″ or higher: Your tire’s tread depth is sufficient. 5/32″: If snow-covered roads are a concern, you should consider replacing your tires. 4/32″: If you frequently drive on wet roads, consider replacing your tires. 3/32″: It’s time to start shopping for new tires.
Is 7 32 A good tire tread depth?
A new tire tread will typically have 10/32 of an inch of tread, and some expensive tires may have 12/32 of an inch. So, 7/32 is pretty good, but is not comparable to a new tire.
What percentage of tire tread is 6 32?
If the tread depth is 6/32″, it has 50 percent remaining. If the tread depth is 5/32″, it has 37.5 percent remaining. If the tread depth is 4/32″, it has 25 percent remaining. If the tread depth is 3/32″, it has 12.5 percent remaining.
Is 4mm tread OK?
Any tyre that has a tread depth less than 1.6mm is illegal in the UK. … A tyre with a tread depth of 4mm is a cause for concern as the tyre is 62% worn. At 3mm it is recommended that the tyre should be replaced.
Do cheap Tyres wear quicker?
Cheap tyres will often wear quicker than premium tyres from manufacturers such as Goodyear, Michelin and Dunlop. … This means you can spread the cost of your tyres, making the cost of premium quality, safer and better performing tyres much more manageable.
Is 4mm tire tread OK?
For safe driving, tires must be replaced at 3 or 4 mm remaining tread depth.